Allied Telesis AT-S63 - Manual (Page 526)

Chapter 28: Spanning Tree Protocol (STP) Commands
526 Section V: Spanning Tree Protocols
Description
This command is used to configure the following STP parameters settings
for port:
ˆ Port cost
ˆ Port priority
Examples
The following command sets the port cost to 15 and the port priority to 192
(increment 12) for port 6:
set stp port=6 portcost=15 portpriority=12
The following command sets the port cost to auto-detect on ports 7 to 10:
set stp port=7-10 portcost=auto
AlliedWare Plus
Command
Syntax
spanning-tree path-cost path-cost
spanning-tree priority priority
Mode
Port Interface mode
Description
This AlliedWare Plus command is identical to the standard command.
Table 15. Port Priority Value Increments
Increment
Port
Priority
Increment
Port
Priority
0 0 8 128
1 16 9 144
2 32 10 160
3 48 11 176
4 64 12 192
5 80 13 208
6 96 14 224
7 112 15 240