Allied Telesis AT-S63 - Manual (Page 724)

Chapter 38: MAC Address-based Port Security Commands
724 Section VIII: Port Security
SHOW SWITCH PORT SECURITYMODE
Syntax
show switch port= port securitymode
Parameters
port Specifies the port whose security mode settings you
want to view. You can display more than one port at a
time. For instructions on how to enter port numbers,
refer to “Port Numbers in Commands” on page 47.
Description
This command displays the security mode settings for the ports on the
switch. An example of the information displayed by this command is
shown in Figure 84.
Figure 84. SHOW SWITCH PORT SECURITYMODE Command
The columns in the display are defined here:
ˆ Port - Port number.
ˆ Security Mode - The current security mode of the port. Possible
settings are Automatic (no security), Limited, Secured, and Locked.
For definitions of the security levels, refer to “SET SWITCH PORT
SECURITYMODE” on page 718.
ˆ Intrusion Action - The action taken by a port operating with the Limited
security level when it detects an intrusion violation.
ˆ Participating - The status of intrusion action on the port. This option
only applies to the Limited security mode and only when a port’s
intrusion action is set to trap or disable. This option does not apply
when intrusion action is set to discard.
ˆ MAC Limit - The maximum number of dynamic MAC addresses the
port can learn. This parameter applies only to the Limited security
mode.
Command
Available
AlliedWare Plus
Port Security Mode Intrusion Action Participating MAC Limit
--------------------------------------------------------------------------
1
Secured ---- ---- ----
2 Limited Trap Yes 20
3 Limited Trap Yes 20
4 Limited Trap Yes 20
5 Automatic ---- ---- ----
6 Automatic ---- ---- ----