Allied Telesis AT-S63 - Manual (Page 597)

AT-S63 Management Software Command Line User’s Guide
Section VI: Virtual LANs 597
SET SWITCH VLANMODE
Syntax
set switch vlanmode=userconfig|dotqmultiple|multiple
[uplinkport=
port ]
Parameters
vlanmode Controls the switch’s VLAN mode. Options are:
userconfig This mode allows you to create your
own port-based and tagged VLANs.
This is the default setting.
dotqmultiple This option configures the switch for
the 802.1Q-compliant multiple VLAN
mode.
multiple This option configures the switch for
the non-802.1Q compliant multiple
VLAN mode.
uplinkport Specifies the port on the switch to function as the uplink
port when the switch is operating in one of the two
multiple VLAN modes. You can specify only one port.
Description
You use this command to configure the switch for one of the multiple
VLAN modes or so that you can create port-based and tagged VLANs.
If you select one of the multiple VLAN modes, you must also set an uplink
port with the UPLINKPORT parameter. You can specify only one uplink
port.
Examples
The following command configures the switch for the 802.1Q-compliant
multiple VLAN mode and specifies port 4 as the uplink port:
set switch vlanmode=dotqmultiple uplinkport=4
The following command sets the switch so that you can create your own
port-based and tagged VLANs:
set switch vlanmode=userconfig