Allied Telesis AT-S63 - Manual (Page 104)

Chapter 4: Enhanced Stacking Commands
104 Section I: Basic Operations
SHOW REMOTELIST
Syntax
show remotelist [sorted by=macaddress|name]
Parameter
sorted Sorts the list either by MAC address or by name. The
default is by MAC address.
Description
This command displays the list of switches in an enhanced stack. The list
does not include the master switch where you started the management
session or switches with a stacking status of unavailable.
Note
You must perform the SHOW REMOTELIST command from the
management session of the master switch where you started the
management session. This command will not work from a slave
switch. Nor will the command work from a master switch that you
accessed through enhanced stacking from another master switch.
To determine the master or slave status of your switch, use “SHOW
SWITCH” on page 93.
An example of the information displayed by this command is shown in
Figure 29.
Figure 29. SHOW REMOTELIST Command
Examples
The following command displays the switches in an enhanced stack,
sorted by MAC address, the default sorting method:
show remotelist
Searching for slave devices. Please wait...
Num MAC Address Name Switch Software Switch
Mode Version Model
-------------------------------------------------------------------------
01
00:21:46:A7:B4:04 Production.. Slave S63 v1.2.0 AT-9424T/SP
02 00:21:46:A7:B4:43 Marketing Slave S63 v1.2.0 AT-9424T/SP
03 00:30:84:00:00:02 Tech Suppo.. Slave S62 v1.3.0 AT-8524M