Allied Telesis AT-S63 - Manual (Page 331)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 331
Description
This command modifies ACLs. You can change the description, action,
classifiers, and ports of an ACL.
Examples
This command changes the description of ACL ID 4:
set acl=4 description=”ARP flow”
This command changes the action of ACL ID 6 to permit and reassigns it
to ports 4 to 7:
set acl=6 action=permit portlist=4-7
This command changes the classifiers of ACL ID 41:
set acl=41 classifierlist=22,24,36
AlliedWare Plus
Command
Syntax
To add access control lists to ports:
service-policy access id
To remove access control lists from ports:
no service-policy access id
Mode
Port Interface mode
Description
You use this command to add and remove ports from access control lists.
You cannot change the description, the action, or the classifier list of an
access control list with the AlliedWare Plus commands.
Example
This example adds port 15 to access control list 5:
awplus> enable
awplus# con
figure terminal
awplus(config)# interface 15
awplus(config-if)#
service-policy access 5