Allied Telesis AT-S63 User Manual
Page 43

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
43
CLASS Command
You use this command to move from the Policy Map mode to the Class
mode to configure traffic classes for Quality of Service policies.
Figure 15. Moving from the Configuration Terminal Mode to the Line
Console Mode with the CLASS Command
INTERFACE PORT Command
You use this command to move from the Configuration Terminal mode to
the Interface mode where you configure the parameter settings of the
ports and add ports to VLANs and Quality of Service policies. This
example enters the Interface mode for port 21.
Figure 16. Moving from the Configuration Terminal Mode to the Interface
Mode with the INTERFACE PORT Command
You can specify more than one port in the command to configure more
than one port at a time. This example enters the Interface mode for ports
11 to 15 and 22.
Figure 17. Specifying More Than One Port in the NTERFACE Command
The INTERFACE command is also located in the Interface mode so that
you don’t have to return to the Configuration Terminal mode to configure a
different port. This example moves from the current Interface mode to the
Interface mode for ports 7 and 10.
Figure 18. Moving within the Port Interface Mode with the INTERFACE
Command
awplus(config-pmap)# class 1
awplus(config-pmap-c)#
awplus(config)# interface 21
awplus(config-if)#
awplus(config)# interface 11-15,22
awplus(config-if)#
awplus(config-if)# interface 7,10
awplus(config-if)#