Allied Telesis AT-S63 - Manual (Page 224)

Chapter 12: LACP Port Trunking Commands
224 Section I: Basic Operations
Figure 41. SHOW LACP Command with the PORT Parameter
The AGGREGATOR parameter displays information about each existing
aggregator. Figure 42 illustrates the information displayed by this
parameter.
Figure 42. SHOW LACP Command with the AGGREGATOR Parameter
Examples
The following command displays general LACP status information:
show lacp
The following command displays the LACP configuration for ports 13 and
16:
show lacp port=13,16
The following command displays the configuration of the aggregators on
the system:
show lacp aggregator
Port ............. 05
Aggregator ....... LACP sw22
ACTOR
PARTNER
============================================
Actor Port ............. 05
Partner Port ......... 00
Selected ............... SELECTED Partner System ....... 00-30-84-AB-EF-CD
Oper Key ............... 0xf705 Oper Key ............ 0xff07
Oper Port Priority .... 0x0005 Oper Port Priority ... 0x0007
Individual ............. NO Individual ........... NO
Synchronized............ YES Synchronized.......... YES
Collecting ............ YES Collecting ........... YES
Distributing ........... YES Distributing ......... YES
Defaulted .............. NO Defaulted ............ NO
Expired ................ NO Expired .............. NO
Actor Churn .......... YES Partner Churn ........ YES
Aggregator # 1 ..... DEFAULT_AGG5
Admin Key .......... 0x0001
Oper Key ........... 0x0045
Speed .............. 1000 Mbps
Distribution Mode .. MACBoth
Ports configured ... 5-8
Ports in LAGID...... 5-8
Aggregated Port .... 5-8