Save configuration, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 57

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Features
57
SAVE CONFIGURATION
Syntax
save configuration
Parameters
None.
Description
This command is used to store the switch’s current configuration in the
active boot configuration file for permanent storage. When you enter the
command, the switch copies its entire configuration into the file as a series
of commands.
Note
You should always enter this command after changing the
parameter settings of a switch because changes that are not saved
are discarded when the switch is reset or powered off.
To view the name of the currently active boot configuration file, see
“SHOW CONFIG” on page 248. To view the contents of a configuration
file, see “SHOW FILE” on page 249.
Example
The following command saves your configuration changes to the active
boot configuration file:
save configuration
AlliedWare Plus
Command
Syntax
write
copy running-config startup-config
Mode
Privileged Exec mode
Description
Both of these commands are identical to the SAVE CONFIGURATION
command. They prompt the switch to update its active configuration file
with its current configuration.
Command
Available
AlliedWare Plus