Allied Telesis AT-S63 - Manual (Page 205)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 205
DESTROY SWITCH TRUNK
Syntax
destroy switch trunk= name
Parameter
trunk Specifies the name of the trunk to be deleted.
Description
This command deletes a static port trunk from a switch. After a port trunk
has been deleted, the ports that made up the trunk can be connected to
different end nodes.
Caution
Disconnect the cables from the port trunk on the switch before
destroying the trunk. Deleting a port trunk without first disconnecting
the cables may create loops in your network topology. Data loops
may result in broadcast storms and poor network performance.
Example
The following command deletes the trunk called load22 from the switch:
destroy switch trunk=load22
AlliedWare Plus
Command
The same AlliedWare Plus command is used to remove ports from static
port trunks and to delete trunks. For instructions, refer to the AlliedWare
Plus command described in “DELETE SWITCH TRUNK” on page 203.
Command
Available
AlliedWare Plus