Allied Telesis AT-S63 User Manual
Page 445
AT-S63 Management Software Command Line User’s Guide
Section III: Snooping Protocols
445
Refer to “SET IPV6 MLDSNOOPING” on page 440 for an explanation of
the parameters.
The HOSTLIST option displays the information in Figure 63.
Figure 63. SHOW IPV6 MLDSNOOPING Command with HOSTLIST
Option
The information is described here:
Multicast Group - The multicast address of the group.
VLAN - The VID of the VLAN where the port is an untagged member.
Port/TrunkID - The port on the switch where the host node is
connected. If the host node is connected to the switch through a trunk,
the trunk ID number, not the port number, is displayed.
HostIP - The IP address of the host node connected to the port.
Exp. Time - The number of seconds remaining before the host is timed
out if no further MLD reports are received from it.
The ROUTERLIST option displays the information in Figure 64.
Figure 64. SHOW IPV6 MLDSNOOPING Command with ROUTERLIST
Option
The information displayed by the option is described here:
VLAN - The VID of the VLAN in which the port is an untagged member.
Port/Trunk ID - The port on the switch where the multicast router is
connected. If the switch learned the router on a port trunk, the trunk ID
number, not the port number, is displayed.
Router IP - The IP address of the multicast router.
Examples
The following command displays the current MLD parameter settings:
show ipv6 mldsnooping
Host List:
Number of MLD Multicast Groups: 1
VLAN
Port/
Exp.
MulticastGroup ID
TrunkID
HostIP
Time
--------------------------------------------------------------------------------------------
33:33:00:00:00:ab
1
6
fe80:0000:0000:0000:0208:74ff:feff:bf08
21
Router List:
VLAN
Port/Trunk ID
RouterIP
--------------------------------------------------------------
1
14
fe80:0000:0000:0000:0200:cdff:fe12:bf08