Allied Telesis AT-S63 - Manual (Page 391)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 391
SHOW QOS FLOWGROUP
Syntax
show qos flowgroup[= idnumber ]
Parameters
flowgroup Specifies the ID of the flow group you want to view. You can
specify more than one classifier at a time.
Description
This command displays the flow groups on a switch. An example is shown
in Figure 54.
Figure 54. SHOW QOS FLOWGROUP Command
The command displays the following information about a flow group:
ˆ Flow Group ID - The flow group’s ID number.
ˆ Description - The flow group’s description.
ˆ DSCP value - The replacement value to write into the DSCP (TOS)
field of the packets.
ˆ Priority - The new user priority value for the packets.
ˆ Remark Priority - Replaces the user priority value in the packets with
the Priority value.
ˆ ToS - Specifies a replacement value to write into the Type of Service
(ToS) field of IPv4 packets. The range is 0 to 7.
ˆ Move ToS to Priority - If set to Yes, replaces the value in the 802.1p
priority field with the value in the ToS priority field on IPv4 packets. If
set to No, which is the default, the packets retain their preexisting
802.1p priority level.
ˆ Move Priority to ToS - If set to Yes, replaces the value in the ToS
priority field with the value in the 802.1p priority field on IPv4 packets. If
Flow Group ID .............. 2
Description ................ Video1
DSCP value ................. 0
Priority ................... 6
Remark Priority ............ No
ToS ........................
Move ToS to Priority ....... No
Move Priority to ToS ....... No
Classifier List ............ 11
Parent Traffic Class ID .... 4
Is Active .................. Yes