Allied Telesis AT-S63 - Manual (Page 160)

Chapter 8: Port Parameter Commands
160 Section I: Basic Operations
To specify the number of cells for backpressure:
holbplimit bplimit
To enable or disable flow control:
flowcontrol receive|send on|off
To enable or disable backpressure:
flowcontrol backpressure on|off
Mode
Port Interface mode
Description
You cannot perform these tasks from the AlliedWare Plus commands:
ˆ Specify the number of cells for flow control.
ˆ Specify the threshold for a head of line blocking event on a port.
ˆ Prompt a port to renegotiate its speed and duplex mode with the end
node.
ˆ Perform a software reset on a port.
Examples
This example sets the speeds on ports 11 and 17 to 100Mbps, half-
duplex:
awplus> enable
awplus# configure terminal
awplus(config)# interface 11,17
awplus(config-if)# speed 100mhalf
This example activates Auto-Negotiation on port 15:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15
awplus(config-if)# speed auto
This example sets the wiring configuration for port 28 to MDI:
awplus> enable
awplus# configure terminal
awplus(config)# interface 28
awplus(config-if)# mdi mdi