Allied Telesis AT-S63 - Manual (Page 215)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 215
Mode
Port Interface mode
Description
This command is used to remove ports from the aggregators and to delete
the aggregators. You delete an aggregator by deleting all of its ports This
differs from the other command line interface where there are different
commands for removing ports and for deleting aggregators.
Deleting the last aggregator on a switch deactivates LACP.
Example
These commands delete ports 11 and 12 from an aggregator named ‘po2’.
The aggregator is deleted if these are its only ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface 11-12
awplus(config-if)# no channel-group 2