Allied Telesis AT-S63 - Manual (Page 267)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 267
Since the file is stored in the switch’s file system and not the application
block, the switch does not use it as its active image file. If, at some point in
the future, you want to make it the active image file, use “LOAD
METHOD=LOCAL” on page 254.
Syntax 2 Example
This command downloads new AT-S63 Management Software into the
application block of a stand-alone switch, making it the active image file on
the switch:
load method=xmodem destfile=appblock
Syntax 3 Examples
This command updates the AT-S63 Management Software on all the
switches in an AT-9400 Stack:
load method=xmodem destfile=appblock module=all
This command updates the AT-S63 Management Software on just the
member switch assigned the stack ID 2:
load method=xmodem destfile=appblock module=2
AlliedWare Plus
Command
Syntax
download serial
Mode
Privileged Exec mode
Description
This AlliedWare Plus command is used to download new versions of the
AT-S63 Management Software into the application block on stand-alone
switches. The file is downloaded using Xmodem through the terminal port
on the unit. After entering the command, use your terminal emulation
program to select the file to download onto the switch.
This command cannot be used to download files, such as configuration
files, into the file system of the switch. For this, use “LOAD
METHOD=XMODEM” on page 263.
Example
awplus> enable
awplus# download serial