Allied Telesis AT-S63 - Manual (Page 607)

AT-S63 Management Software Command Line User’s Guide
Section VI: Virtual LANs 607
SET GARP PORT
Syntax
set garp=gvrp port= port mode=normal|none
Parameters
garp Specifies the GARP application to be configured.
GVRP is the only GARP application supported by the
AT-9400 Switch.
port Specifies the port to be configured. You can specify
more than one port at a time.
mode Specifies the GVRP mode of the port. Modes are:
normal The port participates in GVRP. The port
processes GVRP information and
transmits PDUs. This is the default.
none The port does not participate in GVRP.
The port does not process GVRP
information nor transmit PDUs.
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command sets a port’s GVRP status. Set a port’s mode to Normal if it
is to learn remote VLANs and transmit PDUs. Set its mode to None If it is
not to participate in GVRP.
Examples
The following command prevents ports 1 to 4 from participating in GVRP:
set garp=gvrp port=1-4 mode=none
The following command activates GVRP on port 3:
set garp=gvrp port=3 mode=normal