Allied Telesis AT-S63 - Manual (Page 809)

AT-S63 Management Software Command Line User’s Guide
Section IX: Management Security 809
ENABLE AUTHENTICATION
Syntax
enable authentication
Parameters
None.
Description
This command enables TACACS+ or RADIUS manager account
authentication on a switch or stack. After you enable manager
authentication, you must use the manager accounts you defined on the
TACACS+ or RADIUS server to manage the device. To select an
authenticator protocol, refer to “SET AUTHENTICATION” on page 812.
Note
If you are using the RADIUS authentication protocol for 802.1x Port-
based Network Access Control but not for manager account
authentication, you do not need to use this command. Even when
the RADIUS manager account feature is disabled, the switch still
has access to the RADIUS configuration information for 802.1x port-
based access control.
Example
The following command enables manager account authentication:
enable authentication
AlliedWare Plus
Command
Syntax
login remotelocal
Mode
Line Console mode
Description
This AlliedWare Plus command is identical to the standard command.
Command
Available
AlliedWare Plus