Allied Telesis AT-S63 - Manual (Page 48)

Chapter 2: Port Parameters
48 Section I: Basic Operations
Restoring the Default Settings on the Ports
To restore the default parameter settings to the ports on a switch:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Layer 1 button.
3. Click the Port Settings tab, shown in Figure 6 on page 36.
4. Use the stack ID pull-down menu to select the ID number of a switch
with ports that you want to return to their default values and click the
Apply button. You can configure only one switch at a time. If the
switch is already displayed, you can skip this step.
5. In the switch image, click a port you want to return to the default
values. The selected port turns white. You can configure more than
one port at a time, but they must be the same type (i.e., all twisted pair
ports or all fiber optic ports). To deselect a port, click it again.
6. Click the Modify button. To configure all of the ports on the switch,
click the Modify All button.
7. In the The Port Configuration window, click the Defaults button. The
parameter settings of the selected port(s) are returned to the default
settings.