Allied Telesis AT-S63 - Manual (Page 156)

Chapter 11: SNMPv3
156 Section III: SNMPv3
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Deleting a Notify
Table Entry
To delete an entry from the SNMPv3 Notify Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure Notify
Table, and the Configure button to display the SNMPv3 Notify Table
tab in Figure 50 on page 154.
4. Click the radio button for the Notify Table entry you want to delete, and
then click Remove.
5. At the confirmation prompt, click the OK button.
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Modifying a
Notify Table
Entry
To modify an entry in the SNMPv3 Notify Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure Notify
Table, and then click the Configure button to display the SNMPv3
Notify Table tab in Figure 50 on page 154.
4. Click the radio button of the table entry you want to change and then
click the Modify button to display the Modify SNMPv3 Notify window.
An example of the window is shown in Figure 52.
Storage Type (continued) N-NonVolatile - This setting allows the stack to save the entry
in the master configuration file when the save command is
issued. Allied Telesis recommends this storage type.
Row Status The status of the entry. All entries have a status of Active.
Table 26. SNMPv3 Notify Table Parameters
Parameter Description