Allied Telesis AT-S63 - Manual (Page 24)

Chapter 1: Basic Switch Parameters
24 Section I: Basic Operations
Setting the System Date and Time
The master switch adds the date and time to the event messages that it
stores in the event logs and sends to a syslog server. It also adds the date
and time to SNMP traps. To set the date and time:
1. From the Home page, click the Configuration button.
2. Click the System button in the Configuration menu.
3. Select the System Time tab, shown in Figure 2.
Figure 2. System Time Tab
Note
Because a stack does not support SNTP, do not adjust the values in
the Additional Time Parameters section or the Simple Network Time
Protocol (SNTP) Settings section of the tab.
4. In the System Time section of the tab, enter the time and date in the
following formats.
hh:mm:ss dd-mm-yyyy