Allied Telesis AT-S63 - Manual (Page 214)

Chapter 13: Port-based and Tagged VLANs
214 Secton V: Virtual LANs
Adding or Removing VLAN Ports
This procedure is used to add or remove ports from tagged or untagged
VLANs. Here are a few guidelines:
 You cannot change the VID of a VLAN. If you need to change a
VLAN’s ID number, you have to delete and recreate the VLAN.
 To change the name of a VLAN, you have to use the command line
commands.
 A port that is set to the supplicant or authenticator role in 802.1x Port-
based Network Access Control cannot be moved to a different VLAN
until you change its role to “None.” For instructions, refer to “Setting
the Port Roles” on page 222.
To add or remove ports from a VLAN:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Layer 2 button.
3. Click the VLAN tab, shown in Figure 81 on page 210.
4. Click the radio button of the VLAN you want to modify. You can modify
only one VLAN at a time.
5. Click the Modify button to display the Modify VLAN popup window. An
example of the window is shown in Figure 83.
Figure 83. Modify VLAN Window