Allied Telesis AT-S63 - Manual (Page 161)

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 161
5. Click the Remove button.
6. At the confirmation prompt, click the OK button.
7. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Modifying a
Target Address
Table Entry
To modify an entry in the SNMPv3 Target Address Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure Target
Address Table and then click the Configure button to display the
SNMPv3 Target Address Table tab in Figure 53 on page 158.
4. Toggle through the entries with the Next and Previous buttons until
the table displays the entry you want to modify.
5. Click the Modify button to display the Modify SNMPv3 Target Address
window. An example of the window is shown in Figure 55.
Figure 55. Modify SNMPv3 Target Address Page
6. Modify the parameters, described in Table 27 on page 159, as
needed.
7. After modifying the entry, click the Apply button.
8. At the confirmation prompt, click the OK button.