Allied Telesis AT-S63 - Manual (Page 148)

Chapter 11: SNMPv3
148 Section III: SNMPv3
Deleting an
Access Table
Entry
To delete an entry from the SNMPv3 Access Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure
Access Table and then the Configure button to display the SNMPv3
Access Table tab in Figure 44 on page 144.
4. Toggle through the access table entries using the Next and Previous
buttons to display the entry you want to delete.
5. Click the Remove button.
6. At the confirmation prompt, click the OK button.
7. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click the Configure button to display the SNMPv3
Access Table tab in Figure 44 on page 144.
4. Toggle through the access table entries using the Next and Previous
buttons to display the entry you want to modify.
5. Click the Modify button to display the entry’s Modify SNMPv3 Access
window. An example of the window is shown in Figure 46.