Allied Telesis AT-S63 - Manual (Page 34)

Chapter 1: Basic Switch Parameters
34 Section I: Basic Operations
Default Gateway If the stack has more than one routing
interface, this field displays the IP address
of the next hop of the stack’s default
route. The stack uses the default route
when it receives a network packet for
routing, but cannot find a route for it in the
routing table. This field will contain 0.0.0.0
if no default route is defined on the stack.
If the only routing interface on the stack is
the local interface, this field displays the
default gateway address. This is the IP
address of a router interface on your
network. The stack uses this address as
the next hop to reaching a remote network
device when the stack’s local interface
and the remote device are on different
subnets. The default value is 0.0.0.0.
System Up Time The length of time since the stack was last
reset or power cycled.
Software Information Section
Application Software The version number and build date of the
AT-S63 Management Software.
Bootloader The version number and build date of the
AT-S63 bootloader.
Hardware Information Section
Power Information The status of the main power supply, the
redundant power supply (if present), and
internal power consumption of the master
switch.
Temperature (Deg.C) The ambient temperature as measured
where the air enters the cooling vents on
the side of the unit.
Fan Information The speed or operating status of the
system fans on the master switch.
Table 4. General Tab
Parameter Definition