American Power Conversion 250 A - Manual (Page 92)

82 InfraStruXure Power Generation System
If Source 2 is a Generator that is Not an APC
InfraStruXure Generator
Differences in your system from information presented in this manual
The ATS was designed for operation with an APC InfraStruXure generator, and this manual assumes
that Source 2 is an APC InfraStruXure generator. If using a non-APC generator instead of an APC
generator, almost all references to the “generator” will still be applicable. However, non-APC
generators will generally function differently than APC generators. Therefore, the following sections
will not apply to your system and should be disregarded:
• “Generator start sequence” on page 7
• “Generator cool-down” on page 7
• “Fuel monitoring/runtime calculation” on page 9
• “Communication converter,” (item 4) on page 13
• “Resetting automatic operation on the generator” on page 20
• “Generator” on page 37
• “Fuel Alarm Limits” on page 44
Note
If your installation includes a non-APC generator, the APC Field Service Engineer
performing your start-up will configure your ATS to operate with this generator.