American Power Conversion 250 A - Manual (Page 55)

InfraStruXure Power Generation System 45
Config
System/Network
System/Network
Contacts & Relays
Sub-Feed Config.
Factory Defaults
Manufacturer Data
System ID
Firmware Updates
Electrical Config.
This menu consists of the following items:
System Password • Password: You can change the system password required to access protected
screens and fields in the display interface. Enter a string of up to eight
alphanumeric characters, and then add the underline character (_) to indicate the
end of the string. The default password is apc.
• Timeout: Set the time the display interface will wait for user input before it
reverts to the initial scrolling of status screens. Select 1, 2, 5, 10 (the default), or
30 minutes; or 1, 2, or 4 hours; or forever.
• Invalidate NOW: Allows you to re-enter your system password for viewing
password-protected screens.
Date/Time • Date: Set using the following format: dd-mmm yyyy.
• Time: Set using the following format: hh:mm:ss
Local Interface • Contrast: Set the screen contrast for the LCD. Select from 1 (high contrast) to 8
(low contrast).
• Key Click: Choose On for an audible click whenever you press a navigation
button. Choose Off to disable the click.
• Beeper Volume: Select High, Medium, Low, or Off to adjust the loudness of
both the audible beeper and the click.
• Metric Units: Choose On to view all data as metric values (e.g., meters) and Off
to view data as U.S. standard units (e.g., feet).
Network Config • IP: The system IP address.
• SM: The subnet mask, which identifies the subnetwork on which the ATS
operates.
• GW: The default gateway used by the ATS. The MAC address is displayed in
brackets at the bottom of the screen.