American Power Conversion 250 A - Manual (Page 41)

Overview
InfraStruXure Power Generation System 31
Navigating through screens
To open any screen, press the Up or Down arrow until the selector (   rests next to your desired
selection. Press E NTER to view the selected screen.
When configuring settings, press the Up or Down arrows until the
selector (   rests next to the setting you want to change, and then
press E NTER . If the setting is a list of choices, an input arrow (  
will appear next to the setting. Press the Up or Down arrow until
your desired change appears. Press E NTER to select the setting.
On some screens, continue arrows (   indicate there are
additional screens to view in the category. Press the Up or
Down arrow to view these additional screens.
Password-protected screens
When configuring or changing settings, the display interface prompts you for your password. To
enter your password:
1. Press the Up or Down arrow until the correct letter is
displayed, and then press E NTER .
2. Press E NTER twice after entering your password.
Contacts In: 02of04
Name: User Switch #2
Normal: Open
Status: Open

Load-Meter
ATS/Voltage
Generator
Testing Stats
Alarms
Config
Help
Contacts In: 02of04
Name: User Switch #2
Normal: Open
Status: Open

System/Network
Electrical Configuration
Panel Configuration
Manufacturer Data
Product Data
Factory Defaults
Firmware Updates

Note
After pressing E NTER , the character you entered is
displayed as an asterisk and the input arrow
moves to the next space. Select the next
password character and then E NTER , etc.
See “System Password” on page 45 to change your password.
Enter Password:
*******