Red Lion PAX2D - Manual (Page 26)

26
REGISTER
ADDRESS
REGISTER NAME LOW LIMIT HIGH LIMIT
FACTORY
SETTING
ACCESS COMMENTS
FREQUENTLY USED REGISTERS
40001 Counter A Value (Hi word)
-199999999 999999999 0 Read/Write
40002 Counter A Value (Lo word)
40003 Counter B Value (Hi word)
-199999999 999999999 0 Read/Write
40004 Counter B Value (Lo word)
40005 Counter C Value (Hi word)
-199999999 999999999 0 Read/Write
40006 Counter C Value (Lo word)
40007 Rate A Value (Hi word)
N/A N/A N/A Read Only
40008 Rate A Value (Lo word)
40009 Rate B Value (Hi word)
N/A N/A N/A Read Only
40010 Rate B Value (Lo word)
40011 Rate C Value (Hi word)
N/A N/A N/A Read Only
40012 Rate C Value (Lo word)
40013 Max (Hi) Value (Hi word)
-199999 999999 0 Read/Write
40014 Max (Hi) Value (Lo word)
40015 Min (Lo) Value (Hi word)
-199999 999999 0 Read/Write
40016 Min (Lo) Value (Lo word)
40017 Setpoint 1 Value (Hi word)
-199999 999999 100 Read/Write Active List (A or B)
40018 Setpoint 1 Value (Lo word)
40019 Setpoint 2 Value (Hi word)
-199999 999999 200 Read/Write Active List (A or B)
40020 Setpoint 2 Value (Lo word)
40021 Setpoint 3 Value (Hi word)
-199999 999999 300 Read/Write Active List (A or B)
40022 Setpoint 3 Value (Lo word)
40023 Setpoint 4 Value (Hi word)
-199999 999999 400 Read/Write Active List (A or B)
40024 Setpoint 4 Value (Lo word)
40025 Counter A Scale Factor (Hi word)
1 999999 100000 Read/Write Active List (A or B)
40026 Counter A Scale Factor (Lo word)
40027 Counter B Scale Factor (Hi word)
1 999999 100000 Read/Write Active List (A or B)
40028 Counter B Scale Factor (Lo word)
40029 Counter C Scale Factor (Hi word)
1 999999 100000 Read/Write Active List (A or B)
40030 Counter C Scale Factor (Lo word)
40031 Counter A Count Load (Hi word)
-199999 999999 500 Read/Write Active List (A or B)
40032 Counter A Count Load (Lo word)
40033 Counter B Count Load (Hi word)
-199999 999999 500 Read/Write Active List (A or B)
40034 Counter B Count Load (Lo word)
40035 Counter C Count Load (Hi word)
-199999 999999 500 Read/Write Active List (A or B)
40036 Counter C Count Load (Lo word)
40037 Setpoint Output Register (SOR) 0 15 N/A Read/Write
Status of Setpoint Outputs. Bit State: 0=Off, 1=On.
Bit 3 = S1, Bit 2 = S2, Bit 1 = S3, Bit 0 = S4.
Outputs can only be activated/reset with this register when the
respective bits in the Manual Mode Register (MMR) are set.
40038 Manual Mode Register (MMR) 0 31 0 Read/Write Bit State: 0 = Auto Mode, 1 = Manual Mode Bit 4 = S1, Bit 3 =
S2, Bit 2 = S3, Bit 1 = S4, Bit 0 = Linear Output
40039 Reset Output Register 0 15 0 Read/Write Bit State: 1= Reset Output, bit is returned to zero following
reset processing; Bit 3 = S1, Bit 2 = S2, Bit 1 = S3, Bit 0 = S4
40040 Analog Output Register (AOR) 0 4095 0 Read/Write Linear Output Card written to only if Linear Output is in Manual
Mode (MMR bit 0 = 1).
PAX2D FRERQUENTLY USED MODBUS REGISTER TABLE
Only frequently used registers are shown below. The entire Modbus Register Table can be found at www.redlion.net.
Values less than 65,535 will be in (Lo word). Values greater than 65,535 will continue into (Hi word). Negative values are represented by two’s complement of the
combined (Hi word) and (Lo word).
Note 1: The PAX2D should not be powered down while parameters are being changed. Doing so may corrupt the non-volatile memory resulting in checksum errors.