Installing mast dkp210 – Vaisala AWS330 User Manual
Page 48
User's Guide ______________________________________________________________________
46 __________________________________________________________________ M211296EN-B
Installing Mast DKP210
DKP210 is a 10-meter tiltable mast. The mast is designed to withstand
high wind conditions, up to 50 m/s of maximum wind speed, with a
standard set of guy wires. The plate of the pedestal tube is made of
stainless steel with a powder coating resistant to corrosion. The material
of the lifting rod and mast tubes is anodized aluminum.
CAUTION
Do not install the mast when wind speed is over 7 m/s.
NOTE
Wind sensors WMT703 and WA15 positioned on top of the mast require
exact bearings (north, south). Take time to position the mast correctly, as
instructed here, and verify the directions carefully. This will make correct
aligning of the wind sensors significantly easier.