Vaisala DMT340 - Manual (Page 102)

User's Guide _______________________________________________________________________
100 __________________________________________________________________ M210704EN-G
Outputting Reading Once
Use the SEND command to output the reading once in STOP mode. The
output format depends on which parameters the transmitter can output.
SEND
Examples:
>send
Tdf= -5.8 'C H2O= 3715 ppmV x= 2.3 g/kg
>send
Tdf= -5.9 'C Td= -6.6 'C Tdfa= -5.9 'C Tda= -6.6 'C H2O=
3696 ppmV x= 2.3 g/kg RH= 13.9 %RH a= 2.7 g/m3 aNTP=
3.0 g/m3 T= 22.2 'C dT= 28.1 'C
Assign an Alias for the SEND Command
Use the SCOM command to assign a new command that works like the
SEND command. The standard SEND command of the transmitter will
always function normally whatever the SCOM definition may be.
Command names are case-insensitive.
SCOM
Example (assigning the command MEASURE as an alias for the SEND
command):
>scom
Send command : ? measure
>measure
Tdf= -5.8 'C H2O= 3715 ppmV x= 2.3 g/kg
>
You can remove the SCOM definition by pressing Esc when entering the
command name:
>scom
Send command : measure ?
>