DAVIS Energy EnviroMonitor: Console - Manual (Page 61)

Using the Energy EnviroMonitor
Page 54 Energy EnviroMonitor Manual
Stopping a Scan Routine
A scan routine will continue until you manually stop it or an alarm is triggered.
To stop a scan routine, simply press any function key. The unit will cease
cycling through the scan routine and display the appropriate condition.
P RIMARY P OWER AND B ATTERY B ACKUP I NDICATORS
The Energy EM display contains two “troubleshooting” indicators which help
protect against accidental interruption of power. Both indicators appear in the
upper left hand corner of the display and they may appear singly or together.
Flashing of the POWER indicator indicates low power state or a disruption of
the primary power source (the power source connected to the POWER jack on
the bottom of the unit). If you see this indicator, check the connection of the pri-
mary power from the POWER jack all the way to the power source.
POWER I NDICATOR
Flashing of the BATT indicator indicates that the backup battery is low on
power. You should replace the battery when you see this indicator, or the
backup battery may not last through an unexpected power outage and data
will be lost.
BATT I NDICATOR