DAVIS Energy EnviroMonitor: Console - Manual (Page 56)

Alarms
Energy EnviroMonitor Manual Page 49
3. Press ENTER to activate the alarm.
There is only one threshold for the dew-point alarm—2˚F—which will
appear in the display when you press ENTER. Pressing ENTER again has no
effect.
D EW -P OINT A LARM (2˚F)
4. Press DEW to save and exit.
The alarm is now set and will sound when the temperature comes within
2˚F of the dew-point.
To Silence an Alarm
To silence an alarm that has been triggered, press CLEAR. The beeping sound
stops, though the alarm is not clear. The word ALARM and the function trig-
gering the alarm remain on the display until alarm conditions are no longer
met or the alarm is clear (as explained below).
To Clear an Alarm
1. Press the appropriate key(s) to display the desired weather condition.
Note that, when an alarm has been triggered, the weather condition causing
the alarm will appear on the display automatically (see “The Alarm Dis-
play” on page 46). If more than one alarm has been triggered at once, wait
until the weather condition you want to clear appears on the display and
then press ALARM.
2. Press ALARM as necessary to display the desired alarm threshold (high or low) for
that function.
3. Press and hold down CLEAR until a series of dashes replaces the alarm threshold on
the display.
A LARM C LEARED
4. Press any key to exit.
Each alarm threshold is independent of every other. For instance, clearing
the high air temperature alarm does not clear the low air temperature alarm.
You must clear each alarm individually.