Enabling/disabling autoclear, General high/low clear – DAVIS Energy EnviroMonitor: Console User Manual
Page 57

Using the Energy EnviroMonitor
Page 50
Energy EnviroMonitor Manual
E
NABLING
/D
ISABLING
A
UTO
C
LEAR
The general procedure for enabling and disabling the AutoClear function for
individual weather conditions is covered below.
1. Press the appropriate key(s) to display the desired weather condition’s AutoClear dis-
play.
T
YPICAL
A
UTO
C
LEAR
S
TATUS
D
ISPLAY
2. Press ENTER to alternate the status between on and off.
3. Press any function key to save and exit.
G
ENERAL
H
IGH
/L
OW
C
LEAR
The Energy EM includes a general clear feature which enables you to quickly
clear most of the high and low registers. The general clear feature, however,
will not clear any high/low value for which AutoClear (see “AutoClear” on
page 12) has been turned on. The following registers are cleared by the general
clear feature:
• High and Low Outside Temperature
• High T-H Index
• Low Wind Chill
• High and Low Inside Temperature
• High Wind Speed
• High and Low Humidity
The following registers are NOT cleared by the general clear feature:
• “Daily” Cooling Degree-Days and “Daily” T-H Index Cooling Degree-Days
• “Daily” Heating Degree-Days and “Daily” Wind Chill Heating Degree-Days
• “Daily” Solar Energy
• “Daily” Rainfall
• Total Rainfall
• High Rate of Rainfall