Telenav for Unlocked Supported Devices: Mobile Office - HTC Shift - Manual (Page 129)

Appendix 129
A.2 Regulatory Notices
Regulatory Agency Identifications
For regulatory identification purposes, your product is assigned a model number of
CLIO100.
To ensure continued reliable and safe operation of your device, use only the
accessories listed below with your CLIO100.
The Battery Pack has been assigned a model number of CLIO160.
Note This product is intended for use with a certified Class 2 or Class 3 Limited
Power Source, rated 12 Volts DC, maximum 3 Amp power supply unit.
Federal Communications Commission Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or TV reception, which can be determined by turning the equipment on and
off, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to the
device that are not expressly approved by High Tech Computer Corporation may void
the user’s authority to operate the equipment.