beautypg.com

Port trunk - state activity – American Fibertek SM10p-PoE User Manual

Page 74

background image

















Port Trunk – Aggregator Information interface



Port Trunk - State Activity


When you had setup the LACP aggregator, you can configure port state activity. You can

mark or un-mark the port. When you mark the port and click

Apply

button the port

state activity will change to Active. Opposite is Passive.

¢

Active: The port automatically sends LACP protocol packets.

¢ Passive: The port does not automatically send LACP protocol packets, and

responds only if it receives LACP protocol packets from the opposite device.


Note 1. A link has either two active LACP ports or one active port can

perform dynamic LACP trunk.

2. A link has two passive LACP ports will not perform dynamic LACP trunk

because both ports are waiting for an LACP protocol packet from the

opposite device.

3. If you are active LACP’s actor, after you have selected trunk port, the active

status will be created automatically.














67