American Fibertek SM10p-PoE - Manual (Page 62)

System Event Log - SMTP Configuration
You can set up the mail server IP, mail account, account password, and forwarded email
account for receiving the event alert.
¢ Email Alert: enable or disable the email alert function.
¢ SMTP Server IP: set up the mail server IP address (when Email Alert enabled, this
function will then be available).
¢ Sender: key in a complete email address, e.g. [email protected] , to identify
where the event log comes from.
¢ Authentication: mark the check box to enable and configure the email account and
password for authentication (when Email Alert enabled, this function will then
be
available).
¢ Mail Account: set up the email account, e.g. johnadmin , to receive the alert. It must
be an existing email account on the mail server, which you had set up in SMTP
Server IP Address column.
¢ Password: The email account password.
¢ Confirm Password: reconfirm the password.
¢ Rcpt e-mail Address 1 ~ 6: you can assign up to 6 e-mail accounts also to receive
the alert.
¢ Click Apply .
55