American Fibertek SM10p-PoE - Manual (Page 71)

Port Control
In Port control, you can view every port status that depends on user setting and
the negotiation result.
1. Port: select the port that you want to configure.
2. State: Current port status. The port can be set to disable or enable mode. If the port
setting is disable then will not receive or transmit any packet.
3. Negotiation: set auto negotiation status of port.
4. Speed: set the port link speed.
5. Duplex: set full-duplex or half-duplex mode of the port.
6. Flow Control: set flow control function as Enable or Disable in Full Duplex mode.
The default value is Enable.
7. Security: When its state is ‘On’ that means this port accepts only one MAC address
which was configured to be a static MAC address.
8. Click Apply .
Port Control interface
64