American Fibertek SM10p-PoE - Manual (Page 32)

Port Commands Set
Commands Level Description Example
interface fastEthernet
[Portid]
duplex
[full | half]
speed
[10|100|1000|auto]
G Choose the port for
modification.
I Use the duplex
configuration
command to specify
the duplex mode of
operation for Fast
Ethernet.
I Use the speed
configuration
command to specify
the speed mode of
operation for Fast
Ethernet., the speed
can’t be set to 1000 if
the port isn’t a giga
port..
switch(config)#interface
fastEthernet 2
switch(config)#interface
fastEthernet 2
switch(config-if)#duplex full
switch(config)#interface
fastEthernet 2
switch(config-if)#speed 100
no flowcontrol I Disable flow control of switch(config-if)#no flowcontrol
interface
security enable
no security
bandwidth type all
I Enable security of
interface
I Disable security of
interface
I Set interface ingress
limit frame type to
‘accept all frame’
25
switch(config)#interface
fastEthernet 2
switch(config-if)#security enable
switch(config)#interface
fastEthernet 2
switch(config-if)#no security
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth type
all