American Fibertek SM10p-PoE - Manual (Page 34)

state I Use the state interface switch(config)#interface
[Enable | Disable] configuration
command to
specify
the state mode of
fastEthernet 2
switch(config-if)#state Disable
show interface
configuration
show interface status
operation for Ethernet
ports. Use the disable
form of this command
to disable the port.
I show interface
configuration status
I show interface actual
status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
switch(config)#interface
fastEthernet 2
show interface
switch(config-if)#show interface status
I show interface statistic switch(config)#interface
accounting
no accounting
counter
I Clear interface
fastEthernet 2
switch(config-if)#show interface
accounting
switch(config)#interface
Trunk Commands Set
accounting information fastEthernet 2
switch(config-if)#no accounting
Commands Level Description Example
aggregator priority G Set port group system switch(config)#aggregator priority
[1~65535]
aggregator activityport
[Group ID]
[Port Numbers]
priority
G Set activity port
22
switch(config)#aggregator
activityport 2
aggregator group G Assign a trunk group switch(config)#aggregator group
27