HP Insight Control Software for Linux - Manual (Page 47)

•
Task Name This field displays the name of the task that was executed.
•
Tool This field displays the name of the tool that was used.
•
Owner This field displays the user name that currently owns the task.
•
Command This field displays the command used to run the task.
•
Summary Status This field displays the summary status and indicates the status of some tasks.
•
Target This field displays the name of the target collection or individual systems where the task
executed. If you run a custom tool or a MSA tool, this field displays the CMS system name. With MSA
commands, the command resides on the CMS and runs from the CMS for a remote system or list of
systems. Therefore, the target for this type of command always shows as the CMS.
•
Executed As This field displays the user context where the tools were executed from.
•
Start Time This field displays the time when the task was started.
•
End Time This field displays the time when the task was completed or cancelled.
•
Duration This field displays the amount of time it took to run the task.
NOTE: The list of task instances is based on user privileges and access levels. Users with administrative
rights can view all task instances known to the system.
Viewing target details
NOTE: This section appears for SSA tools only.
Target details include the following:
•
Target Name This field displays the name of the target.
•
Status This field displays the status of the target.
•
Exit Code This field represents the success or failure of an executable program. Typically, if the return
value is zero or positive, the executable ran successfully. If a negative value is returned, the executable
failed.
•
The Stdout tab This tab displays the output text information.
•
The Stderr tab This tab displays information if the executable experienced an error.
This tab does not appear for discovery task results.
•
Files Copied tab This tab displays what files are in the process of being copied or have been copied
to the target system. This tab is not present for tools that do not perform any file copies to their target
systems.
To view target details:
Procedure 3-33 View target details
1. From the Task Instance Results section, select a target system from the table below the Summary
Status
.
A window appears.
2. View the target details.
Enabling system shutdown through Data Center Power Control
Data Center Power Control requires all managed nodes to be configured with Secure Shell (SSH) prior to
running a rule as SSH is required for obtaining secure access to the managed nodes.
To configure SSH using Insight managed system setup wizard, perform the following:
Viewing target details 47