HP StoreOnce Backup - Manual (Page 21)

3 VTL (Virtual Tape Libraries) functions
The following topics are covered in this chapter:
•
VTL page (page 21)
•
Libraries page (page 23)
•
Make Replication Target libraries visible to the host (page 38)
Licensing requirements
•
No licensing is required for VTL emulations unless using the Security features, Data at Rest
Encryption, and Secure Erase.
•
VTL replication requires a license on the target site, but only if VTL replication is used.
•
Replication encryption using IPSEC is part of the Security license but is enabled via the CLI.
See the HP StoreOnce Backup system CLI Reference Guide.
VTL Configuration page
Select VTL from the HP StoreOnce menu to display the current VTL configuration.
The HP StoreOnce–VTL page includes the following tabs:
•
Fibre Channel Settings tab (page 21)
•
iSCSI Settings tab (page 23)
NOTE: Equivalent StoreOnce CLI commands are available for the tasks described in this section.
See the HP StoreOnce Backup system CLI Reference Guide.
Fibre Channel Settings tab
If your system supports a Fibre Channel interface, this tab is displayed as the default when you
select HP StoreOnce–VTL.
Table 5 Fibre Channel settings
Description Setting
StoreOnce 4900 and 4700: Four Fibre Channel ports are available. Port
See also Port assignment for StoreOnce Backup systems (page 22) .
StoreOnce 4500, 4210FC/4220, 4420/4430: Two Fibre Channel ports are available.
Libraries can be configured to use the ports in various combinations. See Create a
library (page 27) for more information.
This reflects the current status of each port, which may be OK, Warning, Error, or Not
Used. Warnings occur if the port is not available or is down. They also appear if the Status
VTL Configuration page 21