HP StorageWorks XP Remote Web Console Software - Manual (Page 104)

Command Parameter Value Description
QUERY
DDNAME, SYSNAME, or
UNITADDRESS
DDNAME = dname =
JCL statement identifying
the volume.
SYSNAME = sysxxx =
SYSNAME in the ASSGN
system control statement.
UNITADDRESS = ccuu =
device number.
You should specify only
one parameter of the
three parameters. The
italic part on the left
means that it is the
arbitrary name. For
example, dname means
the arbitrary unique name
of the JCL statement which
identifies the volume.
PATHS Not applicable.
Siz does not use this
parameter. Siz ignores it.
PPRC Restrictions
Table Table 22 on page 104 and describes the restrictions for using PPRC commands with Siz volumes.
Table 22 Restrictions for PPRC Commands
Command Restriction Error Report
ESTPAIR Command
SUSPEND Command
Do not issue ESTPAIR or SUSPEND
command to a PENDING device.
PPRC PENDING STATUS CC = 12
RECOVER Command
Recovery commands are not valid,
because Siz pairs are constructed
within the same storage system
NOTE:
If a recovery command is used
by mistake, the result is the same
as a delete pair command,
except when VOLID is specified.
PPRC PENDING STATUS CC = 8
Table 23 on page 105 lists and describes the restrictions for using parameters of PPRC commands
with Siz volumes.
104 Using PPRC Commands for Hitachi ShadowImage for z/OS