HP StoreEver TapeAssure Software - Manual (Page 15)

•
MAX_TICKET_STORE
The maximum disk space allocated for local ticket storage (in MB) before being sent to the
management station. Defaults to 100 MB, must be at least 10 MB. Changes to this parameter
are dynamic and will take effect immediately.
•
MANAGEMENT_STATION_IP
The IP address of the Command View TL management station receiving monitoring data. Can
be an IPv4 or IPv6 address, or domain name. Changes to this parameter are dynamic and
will take effect immediately.
•
MANAGEMENT_STATION_PORT
The port number on which the TapeAssure monitoring service is listening. Changes to this
parameter will take effect only when the service is started.
◦ The L&TT WebGUI uses port 8200, the default value. The port used by the WebGUI can
be changed.
◦ Command View TL uses port 8099.
•
TICKET_TIMEOUT
The timeout, measured in seconds, for pulling tickets. The default is ten minutes. If any of the
ticket commands take longer than this setting, the system will stop pulling the ticket. Partial
tickets are logged in the LTT Service log file. You must set this parameter to allow for long
commands, such as rewind and unload, to complete.
Changes to this parameter are dynamic and will take effect immediately.
•
POLLING_INTERVAL
The number of minutes between pulling tickets. The default is six hours (four tickets per day).
These tickets are in addition to tickets pulled on application unload.
Use this feature when the backup application is not configured to unload the tape at the end
of the backup. The poll interval can be very large because the ticket is only needed at the end
of the job.
Set to zero to turn off timed tickets completely.
Changes to this parameter are dynamic and will take effect immediately.
NOTE: Because of the passive nature of pulling tickets and use of the filter driver, pulling
TapeAssure tickets will not disrupt backup operations. Pulling a ticket may slow the backup
by a few seconds, but at only four tickets per day, this will only occur at most once per backup.
•
DRIVES_TO_BE_DISABLED
List of drives for which tickets will not be pulled. Use this configuration setting to selectively
disable monitoring of one or more drives. For multiple drives, separate the drive serial numbers
with a comma. For example:
DRIVES_TO_BE_DISABLED=P200000916, HU10018ADR
Installing the LTT Service 15