HP Officejet 600 All-in-One Printer - Manual (Page 31)

1-23
1. Se
ttin
g Up
8. Install the Software -
REQUIRED!
You must install the software before
using your new HP OfficeJet – if you do
not, the HP OfficeJet will not work.
If you don’t have a CD-ROM drive,
contact the HP OfficeJet Fulfillment
Center at 1-888-HPDISKS (1-888-473-
4757) to receive the software on 3.5-inch
floppy diskettes by overnight mail.
Important: If you are upgrading, you
must remove the previous version of HP
OfficeJet software before installing the new version. Refer to
“Uninstalling the software” on page 7-21 for more information.
Turn on your computer.
This step has two sets of instructions: one for Windows 95, and
one for Windows 3.1.
Windows 95:
If the “New Hardware Found” screen displays, close it by clicking
the
X in the upper right corner or the Cancel button.
Insert the HP OfficeJet CD into the CD-ROM drive, or if you have
floppy disks, insert Disk #1 into the floppy drive. If you’re install-
ing from the CD, the HP OfficeJet Welcome screen will be dis-
played after a few seconds. If you’re installing from a floppy disk,
choose
Run from the Windows 95 Start menu, then type
a:\setup.exe where “a:” represents the letter of the floppy drive.
Click OK . Continue at step 3.
Windows 3.1:
Insert the HP OfficeJet CD into the CD-ROM drive, or if you have
floppy disks, insert Disk #1 into the floppy drive. Choose
Run
from the File menu in the Program Manager, then type
d:\setup.exe where “d:” represents the letter of the CD-ROM
drive or floppy drive. Click OK .
1
2