HP Officejet 600 All-in-One Printer - Manual (Page 15)

1-7
1. Se
ttin
g Up
● Load about a 1/2-inch-
thick stack of 20-lb
paper into the paper
supply tray. Make sure
the stack of paper fits
behind the
stack
guides on the lower
part of the tray. Load
paper with the print
side facing toward you.
● Push the front document loading tray backward until it rests
against the paper supply tray. You may want to pull up the paper
extension to support the paper.
Note: See Chapter 6 for detailed instructions on loading envelopes
and other special paper/media types.
7. Connect Your Office
Equipment - IMPORTANT!
When you were installing the fax/
phone line connector in Step 2,
you may have noticed the two
ports on the back of the connector
labeled, “To Phone, Answering
Machine, or Modem.”
This means that you can use either
one of these ports to connect any
of these three types of devices you
have in your office; the two ports
are interchangeable.
Remove the plugs from the two ports. Then refer to the following
instructions to connect your other equipment.
What should you connect?
Based on your specific equipment and the number of telephone lines
you have, there is only
ONE optimum way to connect. Please read the
questions in the following table, circle your answers, then look up the
appropriate setup scenario in the following “How should you
connect?” section.
OJ-14loadpa
Stack
guides
Connect other
equipment to either
of these two ports