HP Scanjet Enterprise 8500 fn1 Document Capture-Workstation - Manual (Page 82)

4. Connect the Ethernet cable to the formatter (1), reconnect power (2), and then press the Power
button to turn on the product (3).
Install an accessory into the hardware integration
pocket
You can install a separately-purchaseable HP accessory (for example, a proximity reader, fingerprint
reader, or magnetic-swipe reader) into the integrated hardware integration pocket (HIP).
NOTE: This procedure describes installing a proximity card reader. Steps identified as if
applicable might not apply to other HIP accessories. Always refer to the installation instructions that
came with your accessory.
To install an accessory into the HIP, follow these steps:
1. Press the Power button to turn off the product (1), and then disconnect the power cable (2)..
74 Chapter 8 Replace and install components