HP Scanjet Enterprise 8500 fn1 Document Capture-Workstation - Manual (Page 23)

until you reach the option that you want to configure. To return to the previous level, touch the Back
button .
NOTE: The Back button is not available on all screens.
To exit the Administration menu, touch the Home button in the upper-left corner of the screen.
The product has built-in Help that explains each of the features that are available through the menus.
Help is available for many menus on the right-hand side of the touch screen.
The table in this section provides general information about each menu. For information about specific
entries in each menu, see the built-in Help.
Table 3-5 Administration menus
Menu item Description
Reports Use this menu to view information pages and reports that are stored internally on the product.
General Settings Use this menu to set options for setting the time and period of inactivity before the product
enters sleep mode.
Scan/Digital Send Settings Use this menu to set up e-mail, save-to-network-folder, save-to-USB-device, and digital-send-
service options.
Fax Settings Use this menu to set up fax-send options.
Display Settings Use this menu to set up basic display and device behavior settings (keypress sound, display
language, network address button display, scanner inactivity timeout, and more).
Network Settings Use this menu to set up I/O timeout options and to access the Jetdirect menu.
Troubleshooting Use this menu to help resolve problems. Available options include access to event logs and
diagnostic tests, ability to retrieve diagnostic data, and ability to generate debugging data.
Jetdirect menus
Administration > Network Settings > Embedded Jetdirect Menu
Table 3-6 Jetdirect menus
Menu item Sub-menu item Sub-menu item Values and Description
Information Print Sec Report Yes : Print the security report.
No (default): Do not print the security report.
TCP/IP Enable On (default): Enable the TCP/IP protocol.
Off : Disable the TCP/IP protocol.
Host Name An alphanumeric string, up to 32 characters, used to
identify the product. This name is listed on the
HP Jetdirect configuration page. The default host name
is NPIxxxxxx, where xxxxxx is the last six digits of the
LAN hardware (MAC) address.
Basic configuration using the Administration menu 15