HP Scanjet Enterprise 8500 fn1 Document Capture-Workstation User Manual
Page 25

Table 3-6
Jetdirect menus (continued)
Menu item
Sub-menu item
Sub-menu item
Values and Description
Manual Settings
(Available only if the
Config Method
item is set to the
Manual
value) Configure parameters directly from the
control panel:
IP Address
: The unique IP address of the product
(n.n.n.n), where n is a value from 0 to 255.
Subnet Mask
: The subnet mask for the product
(m.m.m.m), where m is a value from 0 to 255.
Syslog Server
: The IP address of the syslog server used
to receive and log syslog messages.
Default Gateway
: The IP address of the gateway or
router used for communications with other networks.
Idle Timeout
: The time period, in seconds, after which
an idle TCP data connection is closed (default is 270
seconds, 0 disables the timeout).
Primary DNS
Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Secondary DNS
Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 Settings
Enable
Use this item to enable or disable IPv6 operation on
the server.
On
(default): IPv6 is enabled.
Off
: IPv6 is disabled.
Address
Type the server address, a 32 hexadecimal digit IPv6
node address that uses the colon hexadecimal syntax.
Manual
Use this item to manually set IPv6 addresses on the
server.
Enable
: Select this item and choose the
On
setting to
enable manual configuration, or the
Off
setting to
disable manual configuration.
Address
: Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Basic configuration using the Administration menu
17