Basic configuration using the embedded web server, View or change network settings, Set or change the administrator password – HP Scanjet Enterprise 8500 fn1 Document Capture-Workstation User Manual
Page 33

NOTE:
Making changes to these settings causes the product to turn off and then on. Make changes
only when the product is idle.
1.
At the product control panel, touch the
Administration
button, touch the
Network Settings
menu,
and then touch the
Jetdirect Menu
option.
2.
Touch the down arrow until the
Link Speed
option displays.
3.
Touch the
Save
button. The product turns off and then on.
Basic configuration using the Embedded Web Server
When the product is connected to the network, the Embedded Web Server (EWS) is automatically
available.
To start the EWS, open a web browser on a computer and type the IP address of the product. To find
the IP address or host name, touch the
Network Address
button on the Home screen on the product
control panel.
●
View or change network settings
●
Set or change the administrator password
●
●
●
Configure save to SharePoint options
●
Configure USB storage device settings
●
●
Configure general security settings
●
Configure access control security settings
View or change network settings
You can use the Embedded Web Server to view or change IP configuration settings.
1.
Open the Embedded Web Server.
2.
Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the administrator password
Use the Embedded Web Server to set an administrator password or change an existing password.
When set, you must enter this password before you can access and change configuration settings.
1.
Open the Embedded Web Server and click the Networking tab.
2.
In the left-side pane, click the Authorization option.
NOTE:
If a password has previously been set, you are prompted to type the password. Type the
password, and then click the Apply button.
Basic configuration using the Embedded Web Server
25