HP Insight Management Agents - Manual (Page 122)

Power
•
Auxiliary Power—Displays whether or not the auxiliary power (External Power Cable and/or
Internal Power Cable, which is a 30-pin cable or a 16-pin cable) is connected to the Remote
Insight.
•
Virtual Power Button—Displays whether or not the virtual power button cable is connected to
the Remote Insight.
Modem/COM Port Settings
NOTE: The Modem/COM Port Settings is not supported for Integrated Lights-Out Edition or The
Remote Insight Lights Out Edition.
A series of tables is displayed providing information about any Remote Insight Board modems or
communication ports. The first table title indicates the type of device described like "Internal
Modem", "External Port", "External Modem", "External Direct Connect," or "External XonXoff".
The tables may contain the following:
•
Model—Displays the model of the communication device.
•
Data Settings—This table contains the data settings for the communication device including:
Alarms—Displays if the Remote Insight firmware uses this communication device to deliver
traps. ◦
◦ Non-PPP—Displays if non-PPP connections are allowed on this port.
◦ Baud Rate—Displays the baud rate to be used on this port.
◦ Data Bits—Displays the number of data bits to be used on this port.
◦ Stop Bits—Displays the number of stop bits to be used on this port.
◦ Parity—Displays the type of parity to be used on this port.
◦ Pager Settings—Displays pager settings for the communication device.
◦ Alarms—Displays if the Remote Insight Board firmware uses this port to deliver pages.
◦ Message—Displays the message that appears in the body of the page.
◦ Baud Rate—Displays the baud rate to use for pager messages.
◦ Data Bits—Displays the number of data bits to user for pager messages.
◦ Stop Bits—Displays the number of stop bits to use for pager messages.
◦ Parity—Displays the type of parity to user for pager messages.
•
Modem Control Strings—This table contains the modem control strings for the communication
device including the following:
◦ Reset—Displays the string used to reset the modem.
◦ Initialize—Displays the string used to initialize the modem.
◦ Dial Prefix —Displays the string pre-pended to phone numbers before dialing.
122 Agent information