Load a roll into the printer – HP Designjet T3500 Production eMFP User Manual
Page 66
Load a roll into the printer
To start this procedure, you must have a roll loaded on the spindle. See
.
TIP:
Do not try to open both roll covers at once; this may cause problems. Always close one cover before
opening the other.
NOTE:
The first two steps below are optional: you can start with step 3. However, in this case the printer
will not keep track of the length of the roll, and will print no barcode on the roll when it is next unloaded. So
you are recommended to follow all the steps, starting with step 1, unless you have turned off the Printing
paper info option. See
Printing paper info on page 66
.
1.
From the front panel, press
if it is not already highlighted, then the roll icon, then Load.
Alternatively, press
, then Paper > Load paper > Load roll 1 or Load roll 2.
If the roll you have selected is already loaded, you have to wait while it is automatically unloaded.
2.
If you start to load roll 1 while roll 2 is already loaded, roll 2 is withdrawn to the standby position, so
that it can be printed on again without reloading whenever required (and vice versa).
NOTE:
If at any time you open a roll cover while that roll is loaded but not printing, the roll will be
automatically unloaded, and you will have to reload it the next time you want to print on it.
3.
Open the roll cover.
56
Chapter 6 Paper handling
ENWW